[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. ⷠNever mow while people, especially children, or pets are nearby. ⷠKeep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor. ⷠDepress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five (5) seconds and release pedal. ⷠStop tractor by turning ignition key to "OFF" position. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Drive in right turns so that the cut grass is thrown away from flower beds and paths, etc. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. Switching off the engine move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to "STOP" position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: · Grasp hood at sides, tilt forward and lift off of tractor. NOTE: Periodic maintenance should be performed on a regular basis in order to keep your tractor in good running condition. WARNING: Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. [. . . ] Your tractor's deck is equipped with a washout port on its surface as part of its deck wash system. ⷠDrive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. IMPORTANT : Make certain the tractor's discharge chute is directed AWAY from your house, garage, parked cars, etc. ⷠPull back the lock collar of the nozzle adapter and push the adapter onto the deck washout port at the left end of the mower deck (C). [. . . ]